Funsicle Sand Filter Pumps

A small build-up of sand in your pool after replacing the sand in your filter or running a backwash is normal. However, if it’s happening outside of those events or it’s a fair amount of sand, then there’s likely an issue with your system. You need to stop using your pool and inspect the filter asap. Continued use could cause injury or irritation for people swimming, and could damage the liner. Shut off your pump and inspect each piece of the filter, including the seals, to check for damage.

The diverter fitting is used to direct the water that is coming out to the filtration system and helps with water circulation.

This could be for a variety of reasons, with the simplest and easiest being to make sure that your pump is plugged in and running properly. It sounds simple, but it’s easy to miss. Next thing to do would be to check the pressure and run the backwash to clear out any debris that may have built up. If you’re using older sand, you may also need to replace it. If those aren’t the issue, then something may be wrong with your pump or filter system. You’ll need to inspect the system and pump for damage and make sure that everything is working properly.

This means that there might be an issue with the pressure in the system, and most likely needs a backwash. Check your pressure gauge to confirm and if it’s higher than normal you’ll need to do a backwash to clear out the filter. To do that, turn off the pump. Never switch modes without turning off the pump first. Then press down on the handle and turn it to backwash. Run the backwash until the drain water runs clear or the drain indicator shows clear water. Then shut the pump off and switch the handle back to filter.

There could be a number of reasons why. First check all hoses and clamps leading to or around the valve. If everything checks out, you may have a faulty O-ring or gasket. If you’re within your warranty period, give our Customer Service team a call. If not, then the valve will need to be opened and the parts replaced. Please take note of what position the valve is sitting before removing it. Putting it back in the wrong position will align the modes in a different order and could seriously damage your entire system.

Try unscrewing the gauge and cleaning it out. Once it’s reattached, see if it’s working again. If not, your gauge may need to be replaced.

Sand filtration uses silica sand for its filtration rather than a filter. It pushes water through the sand, where dirt, debris, and other waste get caught and water is returned to the pool.

First, make sure all wall fittings and return fittings are installed securely. Then attach the tank base and tank to the pump. Put the center pipe in the center of the tank and attach the sand guard to the top of the tank. Fill the tank with number 20 silica sand until it’s between the min and max markings, then remove the guard, but be sure to hang on to it for when you need to replace the sand. Attach the 6-port valve to the top of the sand tank and clamp it in place. Then connect all hoses and clamps to their proper ports. The shortest hose connects the tank to the pump. Then fill your pool and run a backwash to make sure everything is clear. If the water is clear, run the rinse function for one minute, then switch the pump to filter mode and make sure your pressure is in the green. After that, you are good to go.

It all depends on the condition of the sand. When it sits for a long period of time, it can clump together, which reduces the effectiveness of the sand. It may break apart as you run the filter, but it may not, which reduces its ability to filter. You can either hook it up and see how it performs, or just get fresh sand each season so that the pump can function at its best. If you decide to do this method, toss the sand when you go to store your system for the winter, and buy new next season.